Patio
Comfort Glow 11,000 BTU Direct-Vent Liquid Propane Wall Heater (Gray)
Reviews
4.3/ 5
Brand Comfort Glow
- 5 stars 5
- 4 stars 2
- 3 stars 0
- 2 stars 0
- 1 star 1
Product description
This direct-vent liquid propane wall heater provides 11,000 BTUs of heat, rated to warm areas up to 350 square feet. It features an adjustable thermostatic control for maintaining target temperatures. The combustion chamber is fully enclosed, feeding and exhausting air through a direct wall vent so no chimney is necessary. The heater is suitable for bedrooms, bathrooms, HUD housing, mobile and modular homes, and is also approved for use in Canada.
Safety and reliability are emphasized: the unit uses a sealed-burn system with electronic ignition and a safety pilot that incorporates a built-in pressure regulator to halt gas flow if the pilot goes out. The burner is made from 430 stainless steel for quiet, long-lasting operation, and the heater requires no household electricity to run—handy during outages.
The cabinet measures approximately 20 inches high by 17 inches wide by 7 inches deep and mounts to a wall to save floor space. A professional vent kit is included and contains a heat shield, vent pipe, air intake pipe, vent cap, flashing, and a connection rod. The kit supports wall installations between 4.5" and 10" thick. For proper operation the system calls for a minimum 100 lb propane tank and a two-stage low-pressure regulator; follow local codes and manufacturer instructions for safe installation.
Pros
- Runs without household electricity
- Complete vent kit for wall installations
- Sealed-combustion design with safety pilot
Cons
- Requires large propane cylinder and two-stage regulator
- Wall modification and mechanical skill needed for install
- May need occasional adjustment for consistent operation
VerdictA compact, hardwired-free propane wall heater delivering reliable 11,000 BTU output for rooms up to about 350 sq ft. It combines sealed-combustion safety with electronic ignition and an adjustable thermostat, plus a quiet 430 stainless steel burner. The unit is engineered for wall mounting and ships with a complete venting kit for most wall thicknesses, making it a practical choice when grid-free
Reviews
-
Rich 5/5
Reliable without power
Dependable heater that operates as described even during power outages.
-
Steven 5/5
Perfect for my tiny house
I use this in my DIY tiny home and it performs great. I rarely need to crank the thermostat unless temperatures fall into the teens. Compact and effective for the space.
-
Chad 1/5
Has trouble staying lit
Not impressed. The heater repeatedly struggles to remain running. I swapped gas lines, regulators, tanks and tried different orientations. Once it goes past pilot it often shuts off unexpectedly.
-
Jarred 4/5
Heats well but circulation limited
Unit works fine. It doesn't spread heat as evenly as my electric thermal heater, but it passes inspections and meets code. Installation was a bit fiddly.
-
Dan L 5/5
Solid off-grid heater
Installed in my 8.5 x 20 cargo trailer as a hunting camp heater. Took about three hours since I had to build the wall out to the right thickness. Instructions are clear but require some mechanical skill. Package was well packed and the unit feels sturdy. The igniter is now battery-powered which is a welcome update. Fired up immediately and I ran it on high to burn off factory residue. Will report back after some seasonal use.
-
DavieB 5/5
Arrived in good condition, burn-in done
Heater showed up on time and undamaged. I temporarily hooked it to an LP tank and completed the recommended burn-in outside before mounting. Per the manual it emitted some vapors during the first couple hours. Planning to use it to heat my 10' x 20' shed.
-
Alex 5/5
Works well for my workshop
Box had slight damage on arrival but the heater was fine. I converted a 12 x 20 Amish shed into a workshop and this unit heats the space very well.
-
Robert W. 4/5
Good for small rooms
Ideal choice for a small area.
Comments
No comments yet.
Sign in or sign up to comment.